中央空調能量計   :1 3 9 1 5 1 9 1 8 3 6 

 一、工作原理 Work pricipal
      中央空調能量計運用超聲波原理測量，兩個超聲波傳感器直接安裝在流量傳感器通道的兩端，將配對溫度傳感器分別安裝在熱交換回路的進水和回水的管道上，將流量傳感器安裝在入口和出口管上，流量傳感器發出流量信號，配對溫度傳感器給出進水和回水的溫度信號，計算器采集流量信號和溫度信號，經過計算顯示出載熱液體從人口至出口所釋放的熱量值。
      超聲波信號通過這兩個傳感器相互發射，一個信號順流方向，一個信號逆流方向；
      流量的測量是按時差法進行的，時差與流速的大小成正比，可用公式表示：
      組成：由積分儀、超聲波流量計和配對傳感器組成。
      To test by ultrasonic principle,two ultrasonic censor directly fix the two head of the flow censor .The ultrasonic meter to test the flow,temperature test the difference from in to exit water. The calculator take the flow and tempeat-ure signal. And work out the heat quantity. The two ultrasonic sensors transmit to each tach other .
      The way to test the flow quantity is a diffrence way, time and flow speed is direct ratio.Can be denote by this formula:
      Compose:integraph,ultrasonic flow meter, and a part of cencer .
二、中央空調能量計-鍋爐水能量計-冷凍水能量計產品特點 Products Feature
◆
超聲波時差法測量,高測量準確度;
◆
*不受介質中雜質、化學物質和磁性材料影響;
◆
中央空調能量計-鍋爐水能量計-冷凍水能量計測量機構無運動部件，不磨損;
◆
水平、垂直、傾斜或在供回水任意安裝，且無直管段要求;
◆
極小的壓力損失;
◆
直通式超聲波通道，信號不受干擾;
◆
超聲波通道中無反射面，真正水流無阻擋;
◆
管道振動不影響計量;
◆
積分儀外掛式結構，滿足所有安裝要求。
◆
Ultrasonic difference way to test,very accurate.
◆
Not to influence by impurity,mechanical material and magnet material in medium.
◆
The test system has no move part,never abrasion.
◆
Level,vertical,incline or other point of pipe can be fix,and don't need the straight pipe segment.
◆
Small pressure losing.
◆
Straight ultrasonic alleyway,the signal will not be influellce.
◆
The ultrasonic alleyway has no echo face,the curre-nt will not to block.
◆
The vibration will not influent the measure.
◆
The integraph be fix outer,satisfied all of fix request.